Cap-M-Quik MAnual Encapsulator "0" Size
Make 50 capsules in just minutes with the Cap-M-Quik capsule-filling machine.
With Cap-M-Quik, it's easy to turn powders into easy-to-swallow capsules. Fill your capsules with any powdered herbs, food supplements, vitamins, or your own custom formulas. This is an economical and convenient way to take strong-tasting herbs and avoid binders and fillers that are commonly added to store-bought herbs.
FAQs
Can the capsule filling device be used for different size capsules?
No. Each capsule filler is specific to its capsule. For instance, a size '00' filler will only fit size '00' capsules and a size '0' will only work with '0' capsules.
How long does it take to fill 50 capsules?
Less than 7 minutes with a little practice using the filler. Challenge yourself!
What is the plastic capsule filler made of?
The Cap-M-Quik device is made of a very high strength FDA-approved styrene plastic.
Is the filling machine dishwasher safe?
The styrene capsule filler will melt in extremely hot dishwasher cycles, especially if your dishwasher has internal water heating components - even on the top shelf. Your capsule filler, accessories and parts should be hand-washed in sudsy warm water. A small brush might be helpful in cleaning inside the holes.
Note: This product does not contain the "capsule tamper" that is shown on the card inside the box. The tamper is an optional piece that is Sold Separately at Vitamart.
This easy to use machine helps you make 50 capsules at a time in 4 simple steps:
1 – Assemble: Please wash all parts thoroughly and allow to dry before use. Before starting, place capsule holder on a large piece of paper to allow easy cleanup afterwards. Rotate both of the spacers on the end posts so that they are facing the center. Set holder on the four corner posts resting on spacers above base. It should look like this:
2 – Load: Manually separate capsules placing the longer half in holes (top of capsules should be below surface of holder.)
3 – Fill: Pour powdered herbs or vitamins onto holder spreading substance evenly with card, filling all capsules. Remove excess substance carefully by scraping from holder onto the paper that was put down in step 1.
OPTIONAL: The Cap-M-Quik Accessory Tamper could be used at this point to simultaneously pack contents of capsules (sold separately. Vitamart does not carry this accessory. Please see email address on the product box).
4 – Cap: Turn end spacers 90 degrees. Holder will fall exposing upper half of capsules. Manually replace top caps, and remove filled capsules.